Call 131546 and get a quote or book a New Home Inspection for QLD online today.
Jim’s Building Inspections conducts new home inspections (also known as new construction inspections) in QLD and the surrounding areas. Our expert consultants can assist you with every stage of your build and ensure your new build meets your expectations and the necessary standards.
Our local consultants have extensive experience and hold public liability and professional indemnity insurance—meaning you can have peace of mind when you acquire the services of a Jim’s Building Inspector.
We offer same day service for New Home Inspections in QLD and provide written reports via email within 24 hours of the inspection being conducted.
New Home Inspection Checklist
There are four key inspection stages which can be carried out for New Home Inspections:
The slab stage or the base stage inspection is essential in the inspection process. Finished concrete is inspected to ensure there is an even and consistent finish. The surface should not be powdery or flakey. Levels are checked to confirm the slab has been installed within allowable deviation in the over level across and room or the entire build. The edge rebate is checked to ensure it is not “honeycombed” and there is no evidence of steel reinforcement protruding as it must have at least 40mm concrete coverage. The vapour barrier must extend past the poured concrete slab with adequate overlap left so that it extends up the side wall of the slab past the final finished ground level once the construction is completed.
Frame stage inspections are conducted providing an independent assessment of the works to confirm they have been completed ready for stage payment. Internal checks and company appointed inspections are supported with a fresh and focussed and our review monitors the frame with respect to the approved construction methods stipulated in Australian Standard 1684.2 and the Engineers design requirements as detailed on the Approved Plans.
The installation of windows and door frames are checked at this stage. Frame positioning in relation to the supporting slab is checked with any overhanging tolerances along with load bearing timbers, lintels and orientation of Jack Studs above openings. Items such as the correct number of timber blocks and their securing method are checked along with all bracing, mechanical fasteners, tie downs and anchors.
At this stage we inspect the roofing that is installed to ensure it is complete and free of defects and damage, all flashings are installed. A visual inspection is carried out to check the installation of Flashings. Brick work is checked for correct installation. All windows and doors are installed with the correct fixings using appropriate blocks and the frame straight, plumb and true.
The installed plaster to the ceilings, wall linings and fitted cornice is checked to ensure it is installed to acceptable standards. Waterproof membrane to showers & wet areas are inspected to ensure they are correctly installed and comply with the requirements of the Building Code.
Handover Inspections require an exhaustive check of the construction. At handover inspection we check that all the work completed “In a proper and workman like manner” ensuring that the workmanship is at an industry standard. The construction of the dwelling needs to reflect the Approved Plans and we check that all components of the building comply with relevant Australian Standards and Building Codes.
Handover or Final stage inspections are also called Practical Completion Inspections (PCI) and Pre Handover Inspections. Handover inspections are generally carried out on new homes when construction of the entire home has been completed and all internal fittings, fixtures and finishes have been installed and applied inside the home compliant with the relevant building plans and specifications.
To arrange a quote or a building inspection for a property in QLD, call Jim’s Building Inspections on 131546.
Or book your QLD New Home Inspection service online. Reports can be delivered within 24 hours of inspection.
Your Health Health Before MouldImagine if you were battling the following: Nose bleeds, chest infections, sinus troubles, asthma, hair loss, breathing issues, chronic fatigue, rashes and headaches. Sad to say, but these are just some of the potential consequences of living with...
Go With Licensed Pre-Property InspectorsWhat makes a good pre-property inspector? Sourceable’s Howard Ryan writes: ‘To do the job properly, a qualified building inspector will have extensive knowledge of the Building Code of Australia, the Building Act, the Building Regulations and var...
What is Caveat Emptor?Increasingly property buyers are aware of their responsibility to discover building defects before sale – this is known as the Latin principle Caveat Emptor or ‘buyer beware’. The full quotation is ‘caveat emptor, qui ignorare no...
Concrete stumps are not immune to decay under extreme conditions.Many elevated properties sit on some type of stump support whether it be timber , steel , masonry or concrete . Whist most people would consider concrete stumps to be maintenance free , this is far from the truth . Recently one of our Building Inspe...
Fact - Termites Hate Good Building InspectorsA good building inspector knows how to find termite issues. A bad building inspector, by way of contrast, is a termite’s best friend. When Joe Blow (not his real name) bought a two-bedroom 1920s terrace in Sydney’s inner west for around $1 mil...
How Can I Save Money This Year?This year has been a year of challenges. These challenging times are leading to many investors asking the question how can I save money this year? One of the ways many investors can save money is by looking for ways to reduce their tax burden. That ...
Smoke Alarms - America's Move May Trigger Australian ActionIt’s an important topic. Will moves in the United States regarding smoke alarms trigger a debate here? The dirt: As the ABC reported, new US smoke alarm laws look likely to drive ionisation alarms out of business – and an American expert has b...
Three Simple Ways To Fight MouldSome things are out of our control. Others are in our control. Thus, when speaking about mould, there are many things we can do. One: Root causes. Find them. A good place to start: Jim’s Building Inspections. When mould is found by experts it’...
Building? Here Are Mark Campbell's Lessons Learned“My rationale for building new was threefold,” writes Mark Campbell, a working-class Aussie. “Firstly, it enabled me to have control over the end product and it made sense from an investment perspective because I could maximise depreciation and...
Building Inspection Reports - the ultimate negotiation weaponRising damp and termite damage. Two issues that would normally send shivers down your spine and see potential buyers running for the hills. But what if you could you turn a negative building inspection report, into the ultimate negotiation weapon?...